Three Point Starter - Best explained

Three point starter:


three point starter

three point starter

figure shows the schematic diagram of a three point starter for a shunt motor. It is so called because it has three terminals L, F and A. the starter consist of starting resistance divided into several sections and connected in series with the armature. The tapping points of the starting resistance are brought out to a number of studs. The three terminal L, F and A of the starter are connected respectively to the positive line terminal, shunt field terminal and armature terminal. The other terminal of the armature and shunt field windings are connected to the negative terminal of the supply   .the no volt coil is connected in the shunt field circuit. One end of the handle is connected to the terminal L through the over load release coil. The other end of the handle moves against a spiral spring and make contact with each stud during starting operation cutting out more and more starting resistance as it passes over each stud in clockwise direction.

Working of three point starter:

1)      Initially when a DC supply is switched ON with handle in the OFF position.

2)     The handle is now moved clockwise to the first stud, the shunt field winding is directly connected across the supply while the whole starting resistance is inserted in series with the armature circuit.

3)     As the handle is gradually moved over to the final stud, the starting resistance is cut out of the armature circuit in steps. The handle is now held magnetically by the no volt release coil which is energized by shunt field current.

4)     If the supply voltage is suddenly interrupted or if the field excitation is accidently cut, the no volt release coil is demagnetized and the handle goes back to the OFF position under the pull of the spring. If no volt coil were not used, then in case of failure of supply. The handle would remain on the final stud. If then supply is restored, the motor will be directly connected across the supply, resulting in an excessive armature current.

5)     If the motor is overloaded (or any fault occurs) it will draw excessive current from the supply. This current will increase the ampere turns of the overload release coil and pull the armature, thus short circuited the no volt release coil. The no volt coil is demagnetized and the handle is pulled to the OFF position by the spring .thus the motor is automatically disconnected from the supply

Limitations of the three point starter:

Unnecessary tripping of starter if a field regulator is connected in series with the field windings for speed control operation. This combination and magnetizing coil will carry same current if more and more resistance is added in field regulator then current in magnetizing coil is unable to hold the arm in attracted position and unnecessarily the arm will be released even if there is no over loading .this is avoided in four point starter.

You may also like :

four point starter 

If you like this article, please share it with your friends and like or facebook page for future updates. Subscribe to our newsletter to get notifications about our updates via email. If you have any queries, feel free to ask in the comments section below. Have a nice day!

Post a Comment


  1. Supraik bhattacharyaApril 2, 2017 at 2:06 PM

    Very helpful and written in lucid words.

  2. I've been addicted to this topic easily and even shared it with my friends. Thanks to the website for providing such an easy understanding :)

  3. Moreover, the reduction within the labor workforce within the manufacturing sector has led to a lower within the manufacturing rates, which is impacting the market growth. Factors such because the growing globalization and the demand for dependable and low-cost products are expected to boost this machine market income within the forecasted interval. Furthermore, the adoption of advanced automated machines with low-cost offerings is Satin Boxers the main trend in this market. It is due, on a molecular stage, to the polymer chains enjoyable and aligning themselves with adjoining chains. Increased shrinkage happens with more extremely crystalline plastics (e.g. polybutylene terephthalate, PBT) because of the of} formation of more dense crystal constructions. Sink marks may happen in plastic components in areas of thicker cross part such as junctions between facet wall and base the place the plastic is slower to cool.