# Temperature Controlled DC Fan using Thermistor (Mini Project)

Hello friends, in this post we are going to make one simple mini project which is temperature controlled DC fan using a thermistor. In this mini project, we are going to control the speed of the DC fan automatically as the surrounding temperature changes. Thus when the temperature of surrounding increases speed of fan also increases and when temperature decrease speed of fan also decreases. This is achieved by using the principle of the thermistor.

## Components required

• R1 = 4.7K

• R2 = 47 Ohm

• NTC Thermistor = 4.7K

[caption id="" align="aligncenter" width="131"] bead type thermistor[/caption]

• Potentiometer (Vr) = 500K

• OP AMP IC 741

• Transistor T1 = BD140 (or other PNP transistor may work)

• 12V DC fan which is also used in computer (CPU)

• Diode 1N4007

• 12 V DC power supply

## Circuit diagram

The following figure shows a circuit diagram of temperature controlled DC fan using a thermistor.

[caption id="" align="aligncenter" width="383"] Temperature controlled dc fan using thermistor[/caption]

## Working

The basic working principle of temperature controlled DC fan is based on the working principle of the thermistor. The thermistor is a component which changes its resistance as its temperature changes. There are two types of thermistor available which are NTC i.e. negative temperature coefficient and other is PTC which is positive temperature coefficient.

In temperature controlled DC fan, we have used an NTC type thermistor. It is called NTC because its resistance increases when its temperature decreases and vice verse. Similarly, in PTC, its resistance increases when temperature increases and vice verse.

Op amp IC741 is used as a voltage comparator which compares the voltage between its two inputs i.e. inverting and non-inverting terminals. Pin number 2 is inverting terminal which is connected to the potentiometer and pin number 3 is a non inverting terminal which is connected in between thermistor and R1 which makes a voltage divider circuit. Thus the output of op amp is responsible for the speed of the fan.

When the temperature of surrounding increases, the temperature of thermistor also increases which causes its resistance to decrease, therefore voltage divider circuit causes more voltage across pin number 3. Thus the output voltage increases causing the speed of the fan to increase.

### You may also like

If you like this article, please share it with your friends and like or facebook page for future updates. Subscribe to our newsletter to get notifications about our updates via email. If you have any queries, feel free to ask in the comments section below. Have a nice day!

### 6 Comments

1. Where is your office?

2. Hello thanks for services and kind work;please i would like modify it with two leds that will indicate whether the temperature is normal and the other indicates abnormal temperature as the fan runs.thanks

3. How much is current rating for power supply?

4. Enjoy reading the article above, it really explains everything in detail about test tag perth, the article is very interesting and effective. Thank you and good luck with the upcoming article

5. You wrote this post very carefully.Proximity SensorThe amount of information is stunning and also a gainful article for us. Keep sharing this kind of articles, Thank you.

6. You are sharing a piece of nice information here. The information you have provided is genuinely instructive and significant for us. Thanks for sharing an article like this.characteristics of biosensors